ESAB MultiPower 460 Pulse Manual de instrucciones descargar pdf (Pagina 27)

When the WELD PROCESS switch is

moved to the TIG or STICK position,

electrode becomes electrically

“HOT”. Do not allow the electrode

to contact ground potential until you

are ready to make a weld.

NOTE:

Due to the "Built-In" Arc Force in the

stick mode, the actual current may be

greater than the preset value.

Step 5. CV-Carbon Arc Gouging Only - Place the Process Switch in the MIG

position and the Contactor Toggle switch to the "ON" position. See Fig-

ures 4-4 and 4-5.

Step 6. Turn the air on the gouging electrode holder "ON and start gouging by

touching or scratch starting the electrode.

Carbon Arc

Gouging

ONLY!!!!!!!

Figure 4-5 Contactor Switch

for Carbon Arc Setup

I. MIG PULSE WELDING

The Multipower 460PULSE is designed to provide simple to use, high quality,

preprogrammed synergic and non-synergic pulsed Mig welding. Synergic pulsed

Mig welding means that pulse parameters (such as pulse height, pulse width,

background current and pulse frequency) are automatically adjusted by the

Multipower 460PULSE as the wire feed speed is changed by the operator.

A unique non-synergic Mig pulse mode is also offered for welding applications

and wire feeder combinations that cannot use the preprogrammed synergic pulse

data.

Figure 4-4 Carbon Arc Setup Procedure

SECTION 4 OPERATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Sin comentarios

ESAB MultiPower 460 Pulse Manual de instrucciones Pagina 27