ESAB Origo Tig 3000i Manual de instrucciones

GBValid for serial no. 802-xxx-xxxx, 039-xxx-xxxx0459 942 101 GB 20121105Origo™Tig 3000i AC/DCInstruction manual

© ESAB AB 2006- 10 -bt31d1ea5.3 Fan controlThe power source has a time control that means that the fans continue to run for 6.5minutes after welding h

© ESAB AB 2006- 11 -bt31d1ea7 FAULT-TRACINGTry these recommended checks and inspections before sending for an authorisedservice technician.Type of fau

© ESAB AB 2006Diagram - 12 -bt31e

© ESAB AB 2006- 13 -bt31e

Tig 3000i AC/DC© ESAB AB 2006Order number - 14 -bt31oOrdering no. Denomination Type0459 735 880 Welding power source Origo Tig 3000i AC/DC, TA24 A

Tig 3000i AC/DC© ESAB AB 2006Accessories - 15 -bt30aTrolley 2 wheel ...Trolley 4 wheel ...0459 366 890

Tig 3000i AC/DC© ESAB AB 2006- 16 -bt30aRemote control unit AT1 CAN . .MMA and TIG: current0459 491 883Remote control unit AT1 CF CAN ...MMA and

- 17 -notesNOTES...

- 18 -notesNOTES...

- 19 -notesNOTES...

- 2 -

www.esab.com110915© ESAB ABESAB subsidiaries and representative officesEuropeAUSTRIAESAB Ges.m.b.H Vienna-Liesing Tel: +43 1 888 25 11 Fax: +43 1

- 3 -TOCeRights reserved to alter specifications without notice.1 SAFETY 4...2 INTRODUCTION 6.

© ESAB AB 2006- 4 -bt31d1ea1 SAFETYUsers of ESAB equipment have the ultimate responsibility for ensuring that anyone who works on ornear the equipment

© ESAB AB 2006- 5 -bt31d1eaWARNING Read and understand the instruction manual before installing or operating.Arc welding and cutting can be injurious

© ESAB AB 2006- 6 -bt31d1eaDispose of electronic equipment at the recycling facility!In observance of European Directive 2002/96/EC on Waste Electrica

© ESAB AB 2006- 7 -bt31d1eaTig 3000i AC/DCPermissible load at MMA30% duty cycle 60% duty cycle100% duty cycle 300 A / 32 V230 A / 29.2 V190 A / 27.6

© ESAB AB 2006- 8 -bt31d1ea4.1 Lifting instruction4.2 LocationPosition the welding power source such that its cooling air inlets and outlets are notob

© ESAB AB 2006- 9 -bt31d1ea5 OPERATIONGeneral safety regulations for handling the equipment can be found onpage 4. Read through before you start using