ESAB Origo TA23 Manual de instrucciones Pagina 1

GBValid for serial no. 840-xxx-xxxx, 950-xxx-xxxx,039-xxx-xxxx0460 742 001 GB 20121105Origo™Tig 3001iInstruction manual

© ESAB AB 2008- 10 -bt37e5 OPERATIONGeneral safety regulations for handling the equipment can be found onpage 4. Read through before you start using t

© ESAB AB 2008- 11 -bt37e5.1 Connections and control devices1 Control panel, see separate instruction manual5 Connection (-) TIG: Welding torchMMA: We

© ESAB AB 2008- 12 -bt37e5.4 Overheating ProtectionThe welding power source has overheating protection that operates if thetemperature becomes too hig

© ESAB AB 2008- 13 -bt37e7 FAULT-TRACINGTry these recommended checks and inspections before sending for an authorizedservice technician.Type of fault

© ESAB AB 2008Diagram - 14 -bt37e

© ESAB AB 2008Diagram - 15 -bt37e

Tig 3001i© ESAB AB 2008Order number - 16 -bt37o Ordering no. Denomination Type Notes0459 745 883 Welding power source Origot Tig 3001i TA23 with co

Tig 3001i© ESAB AB 2008Accessories - 17 -bt37aTrolley with two wheels ... 0460 564 880Trolley with four wheels ... 04

Tig 3001i© ESAB AB 2008- 18 -bt37aConnection kit for cooling unit ...valid before serial number 039 -xxx-xxxxConnection kit for cooling unit

Tig 3001i© ESAB AB 2008- 19 -bt37aTig torch TXH 200 4 m ...Tig torch TXH 200 8 m ...Tig torch TXH 250w 4 m ...

- 2 -

www.esab.com110915© ESAB ABESAB subsidiaries and representative officesEuropeAUSTRIAESAB Ges.m.b.H Vienna-Liesing Tel: +43 1 888 25 11 Fax: +43 1

- 3 -TOCeRights reserved to alter specifications without notice.1 SAFETY 4...2 INTRODUCTION 6.

© ESAB AB 2008- 4 -bt37e1 SAFETYUsers of ESAB equipment have the ultimate responsibility for ensuring that anyone who works on ornear the equipment ob

© ESAB AB 2008- 5 -bt37eWARNING Read and understand the instruction manual before installing or operating.Arc welding and cutting can be injurious to

© ESAB AB 2008- 6 -bt37eDispose of electronic equipment at the recycling facility!In observance of European Directive 2002/96/EC on Waste Electrical a

© ESAB AB 2008- 7 -bt37e3 TECHNICAL DATATig 3001iMains voltage 400 V $10%, 3 50/60 HzMains supply Ssc min 1.4 MVAPrimary current Imax TIGImax MMA13 A

© ESAB AB 2008- 8 -bt37eDuty cycleThe duty cycle refers to the time as a percentage of a ten-minute period that you can weld or cut ata certain load w

© ESAB AB 2008- 9 -bt37e4.2 LocationPosition the welding power source such that its cooling air inlets and outlets are notobstructed.4.3 Mains supplyN