ESAB Origo TA23 Manual de instrucciones descargar pdf (Pagina 9)

- 9 -

bt37e

4.2 Location

Position the welding power source such that its cooling air inlets and outlets are not

obstructed.

4.3 Mains supply

Note

Mains supply requirements

High power equipment may, due to the primary current drawn from the mains supply, influence the

power quality of the grid. Therefore connection restrictions or requirements regarding the

maximum permissible mains impedance or the required minimum supply capacity at the interface

point to the public grid may apply for some types of equipment (see technical data). In this case it

is the responsibility of the installer or user of the equipment to ensure, by consultation with the

distribution network operator if necessary, that the equipment may be connected.

Make sure that the welding power source is connected to the correct supply voltage

and that it is protected by the correct fuse rating. A protective earth connection must

be made in accordance with regulations.

Rating plate with supply connection data

NOTE! The welding power source is designed for connection to a 400 volt

system with four conductors.

Recommended fuse sizes and minimum cable area

Tig 3001i

Mains voltage 400 V 3 50 Hz

Mains cable area mm

4G4mm

Phase current I

eff

10 A

Fuse

anti-surge

type C MCB

16 A

NOTE! The mains cable areas and fuse sizes as shown above are in accordance with Swedish

regulations. Use the welding power source in accordance with the relevant national regulations.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

ESAB Origo TA23 Manual de instrucciones Pagina 9