ESAB MultiPower 460 Pulse Instrucciones de operaciones descargar pdf (Pagina 13)

Table 5-1 Wire Feeder Compatibility

Wire Feeder

Arc Trim Location

from:

PANEL REMOTE Synergic

Non-

Synergic**

Mig 4HD

DuraDrive 4-30

Feeder X X Optional

DuraDrive 4-48

Remote Pendant X X Optional

MP-460 Panel X X Optional

Mig 2E

Feeder X N/A

Mig 5XL

(Mongoose)

Remote Pendant X X Optional

MP-460 Panel X X Optional

MobileMaster IV

(Off the Arc)

Feeder X N/A N/A X

Mini 8

(Off the Arc)

Remote Pendant X N/A X

MP-460 Panel X N/A X

N/A - Not Available

* - Process switch MUST be in the MIG position.

** - See Synergic/NonSynergic description section for configuration information

MIG STANDARD

(MultiPower 460)

MIG PULSE

(MultiPower 460 Pulse)

MIG MODE SWITCH*

V. OPERATION

A. WIRE FEEDER COMPATIBILITY

The MultiPower 460 Pulse power source can be used with several ESAB 42

volt wire feeders. The model wire feeder being used will determine the setup

method and operator interface. The position of the REMOTE/PANEL switch

determines the location of the voltage preset and TRIM locations. The wire

feed speed is always set from the wire feeder using the wire speed knob on the

feeder control panel. To see the preset wire feed speed, press the PRESET

button on the MultiPower 460 control panel. Use Table 5-1 to determine the

switch position of operator preference. In most Mig welding applications, the

switch will be in the REMOTE position and the wire feed speed and voltage will

be adjusted from the wire feed front panel.

B. DIGITAL DISPLAY METERS

The digital displays located on the left side of the control panel are multifunc-

tional depending on the welding process being used. The MultiPower 460

Pulse digital display meters permit preset or the wire feed speed on wire

feeders without digital displays. A Mig 2E, 4HD or DuraDrive 4-30 or 4-48 will

not need digital meters to preset the wire feed speed. The wire feed speed can

be displayed on the MultiPower 460 panel meter.

C. MIG WELDING

In the MIG process mode, the digital displays will read preset wire feed speed

in inches per minute and preset arc volts when the PRESET button is pressed.

Once welding begins, the displays will show average welding current and volts

in the top and bottom display, respectively. The displays have a “HOLD” circuit

that retains the welding conditions. After welding stops, the display will

continue to show the last welding current and voltage sampled for 10 seconds,

then returns to “0”.

SECTION 3 OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comentarios a estos manuales

Sin comentarios

ESAB MultiPower 460 Pulse Instrucciones de operaciones Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura ESAB MultiPower 460 Pulse