ESAB MultiPower 460 Pulse Manual de instrucciones descargar pdf (Pagina 25)

2.0 INSTALLATION

After checking to be sure you have all required components and accessories (see Section II), proceed as follows:

A. HOSE AND ELECTRICAL CONNECTIONS

1. Connect shielding gas supply hose to the rear panel of the feeder.

2. Connect the 19-pin control cable between the DuraDrive rear panel and power source wire feeder connection.

3. Connect suitably sized power cable between the power source and the power block at the rear base of the feed-

er.

B. CENTER AND OUTLET GUIDES

The DuraDrive 4-30 feed is supplied with .035/.045" "V" groove feed rolls, outlet guide and center guide. Use the procedure

below if alternate accessories are required.

1. Referring to gure 4-1, choose the correct type and size center and outlet guide from Table 4-1.

2. Insert the center guide into the drive stand center support between the front and rear drive axles. Tighten the

locking knob to secure in place.

3. Insert the outlet guide tapered end rst into the front of the MIG gun adapter and secure with locking knob.

C. MIG GUN CONNECTIONS (Gun Master 250 and 400)

1. Connect MIG Gun to feed roll accessory drive by loosening the locking knob on the side of the drive roll accessory

gun adapter and insert the gun power pin into the gun adaptor then tighten locking knob.

2. Connect the gun trigger twist lock plug into the mating receptacle on the front panel of the DuraDrive feeder and

lock by twisting 1/4 turn.

SECTION 2 INSTALLATION

Table 2-1 - DuraDrive 4-30 Feed Roll Table

(4 req'd.)

(1 req'd.)

0459052001

0459052003

0459052013

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Sin comentarios

ESAB MultiPower 460 Pulse Manual de instrucciones Pagina 25