ESAB MultiPower 460 Pulse Manual de instrucciones descargar pdf (Pagina 27)

SECTION 4

OPERATION

F. TIG WELDING

When the PROCESS switch is placed in the TIG position, the MultiPower 460

is automatically set for CC (constant current) welding using the ESAB Touch

TIG starting method. The voltage and current at the output lugs is maintained

at low values until the tungsten electrode is shorted to the workpiece.

Step 1. Be sure to set the polarity to DCEN (Electrode Negative) by con-

necting the Tig torch to the negative terminal lug on the front of the

power source.

Step 2. Place the WELD PROCESS switch in the TIG position.

Step 3. Place the PANEL/REMOTE switch in the PANEL position.

Step 4. While depressing the PRESET button, turn the VOLTAGE/CURRENT

knob to the desired weld current as displayed on the top digital dis-

play window.

Step 5. Set the shielding gas flow rate to 20 cfh by adjusting the control knob

on the flowmeter.

Step 6. Touch the tungsten electrode to the workpiece momentarily then lift

1/16" off the workpiece to establish the welding arc. Trim the weld

current as desired by turning the VOLTAGE/CURRENT knob.

NOTE

If a Foot Control or Remote Hand Control

is used for continuous current control,

place the PANEL/REMOTE switch in the

PANEL POSITION and set the Panel Cur-

rent knob to the maximum desired weld

current. The remote device will then con-

trol the current between minimum and the

maximum setting preset (proportional

current control). Maximum Tig weld cur-

rent is 525 amps.

G. STICK WELDING

When the PROCESS switch is placed in the STICK position, the MultiPower

460 establishes open circuit voltage (OCV) and output power is immediately

available for welding. This means that the STICK electrode holder is “HOT”, and

an arc will strike when the electrode comes in contact with the workpiece or

any other object at ground potential.

NOTE

The FC-5B foot control or TC-2B hand

control must be used with the MP-460 for

remote current Tig current control.

NOTE

If the MP-460 PANEL/REMOTE switch

is left in the REMOTE position when Tig

welding while using a remote current

control device, the current range will

be full scale or 10 to 400 Amps.

Limiting the the maximum weld current

(proportional current control) using the

currnet control on the MP-460 front

panel is defeated.

NOTE

When using a DuraDrive wire feeder

(or any wire feeder with Remote

Voltage control from the feeder front

panel) connected simultaneously with

a remote current control Tig device

(FC-5B or TC-2B), proportional control

of the TIG remote current will be

controlled by the position of the feeder

voltage control knob when the PANEL/

REMOTE switch is in the REMOTE

position. When in the PANEL position

the maximum current of the remote

device is controlled by the MP-460

front panel current control preset.

Step 3 Step 2

Step 4

Figure 4-2 Standard Tig Setup Procedure

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Comentarios a estos manuales

Sin comentarios

ESAB MultiPower 460 Pulse Manual de instrucciones Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura ESAB MultiPower 460 Pulse