ESAB MultiPower 460 Pulse Manual de instrucciones descargar pdf (Pagina 29)

SECTION 4

OPERATION

When the WELD PROCESS switch is

moved to the TIG or STICK position,

electrode becomes electrically “HOT”.

Do not allow the electrode to contact

ground potential until you are ready

to make a weld.

NOTE

Due to the "Built-In" Arc Force in the stick

mode, the actual current may be greater

than the preset value.

Step 4. CV-Carbon Arc Gouging Only - Place the Process Switch in the

MIG position and the Contactor Toggle switch to the "ON" position.

See Figures 4-4 and 4-5.

Step 5. Turn the air on the gouging electrode holder "ON and start gouging by

touching or scratch starting the electrode.

For CV Carbon Arc

Gouging and "Off the

Arc" wire feeders

ONLY!!!!!!!

Figure 4-5 Contactor Switch

for Carbon Arc Setup

Figure 4-4 Carbon Arc Setup Procedure

Step 4

Step 2

Step 1

Step 3

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Sin comentarios

ESAB MultiPower 460 Pulse Manual de instrucciones Pagina 29