ESAB MultiPower 460 Pulse Manual de instrucciones descargar pdf (Pagina 19)

SECTION 2 DESCRIPTION

Figure 2-2. Control Panel

C. Control Panel Description (Refer To Figures 2-2 & 2-3)

1. Fault Lamp

The RED fault light on the MultiPower 460 Pulse front panel indicates a problem with set-up parameters. A "Steady-On"

light indicates there is no program for the material and wire diameter selected. A "Blinking" light indicates the wire feed

speed is out of the recommended range.

2. Temperature Lamp

The TEMP lamp illuminates if an over temperature condition occurs within the MultiPower 460 Pulse power source. This

condition may be caused by excessive duty cycle or over-current conditions. When an over temperature condition occurs,

the welding output is turned oﬀ and the unit must be allowed to cool. The machine will automatically reset when the tem-

perature falls to a safe level.

3. Process Selector Switch

The three position process selector switch is located in the upper right-hand corner of the control panel. The process selector

switch position provides the visual indication of which weld process (Mig, Tig or Stick) has been selected.

4. Digital Display/Meters (WFS, Amps & Volts)

The digital displays located on the left side of the control panel are multifunctional depending on the welding process be-

ing used. The top display reads wire feed speed in inches per minute during MIG PULSE preset and welding current (amps)

during TIG and STICK preset. The bottom display reads power source open circuit voltage during STANDARD Mig preset.

Each display indicates average welding current or average welding voltage, respectively, during welding.

Fault

Lamp

WFS - IPM

Lamp

Amps

Lamp

Digital Meter

Amps/WFS

Power “ON”

Lamp

Temperature

Lamp

Digital Meter

Volts

.045

.040

.035

1/16

.052

WIRE TYPE

WIRE DIAMETER

PULSE SELECTION

EN-625 ERNiCrMo-3

STAINLESS

AL-4000

AL-5000

EN-60 ERNiCu-7

METAL CORE

STEEL

EN-67 ERCuNi

Voltage (CV)

Current (CC)

Trim (Pulse)

TEMP

POWER

BLINKING

WIRE SPEED

OUT OF RANGE

STEADY

NO PROGRAM

PRESET

MIG

LIFT

START

TIG

STICK

REMOTE

PANEL

STANDARD

MIG PULSE

Auto Fan

Fan will cycle automatically

Multipower 460PULSE

WFS-IPM

AMPS

VOLTS

Weld Process

Switch

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 68 69

Comentarios a estos manuales

Sin comentarios

ESAB MultiPower 460 Pulse Manual de instrucciones Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Sistema De Soldadura ESAB MultiPower 460 Pulse